AOSC Forum Archive

SUSAT looks good.

I need that NCStar.. where did you get it again?

And that P90 needs more tacticool to fit in. XD

Hey look, my SVD.

A nice little beauty was added to my collection this weekend, I present the TM L96 AWS:

Awesome!

Now I expect you to make a realistic barrel to match the magazine!

hmmmm, something like this?



Seems like all I'd need to do is add the flash hider. In which case I could get a thread adapter and find the right flash hider.

On a side note, turns out this is my second British rifle in my collection... maybe I should try to make some sort of load out to go along with the weapons...

This is my VFC HK417D.

Externally it has:
Magpul MBUS in FDE
Magpul XTMs in FDE and OD
Magpul AFG2 in FDE
LaRue Tactical scope mount
Leapers 1-4X24 Shotgun Scope
Scatterplot Carbon Fiber Mock Suppressor

Internally:
Riot 10:1 gear set
SHS 15t Piston
Stock VFC Bushings
Stock VFC piston head
Stock VFC cylinder
Stock VFC cylinder head
Stock VFC air nozzle
Stock VFC tappet plate.
Extreme-Fire Cheetah Mosfet with TriggerMaster v5.0 software
Core 455mm 6.03 Tightbore Barrel
ER-hop
Element M135 spring
Stock VFC Spring guide
Lonex A2 Motor

Custom modifications:
AFG2 is copped to allow room for my hand behind it, and up against the magwell.
Wooden wedges under the rail system to stabilize the outer barrel.
Slight sanding on the rear MBUS sight to allow the scope mount to sit all the way back for proper eye relief.
Gearbox reinforcement was in the way of the 10:1 bevel, required modification to remove the extra material to allow the gear to fit.
New, longer trigger contacts, not quite a hair trigger, but still better than the longer stock trigger pull.
The modifications required to install an ER-hop.
Barrel has also been stabilized with a small wooden wedge.

Gets 44rps on an 11.1v 2650mah 20c battery
Chronos at 398fps with .25s +/- 2fps. (perfect for the 400fps full auto cap)

I know it's not quite a bullpup, but it's certainly one of the nicest guns I've ever built, much less owned. I had the time to snap a few pictures this norming and figured I'd post up the build so you guys could see what's inside. And to brag a little. 400fps at 44rps. Woo!

Major kudos on that build kory. Looks amazing. How is the quality on that larue SPR mount?

Very good, thank you very much for the suggestion. It's a tad, just a tad bit fuzzy when you look close, but all in all, for a $24 mount, It's excellent.

Its very... clean.

That 417........... :O <3

DAT 417

That's not a bullpup.

Look who's trying to get to 5000 posts first ^

Steevo copying my Facebook comment. Tsk tsk

It was the first and only snarky comment that came to mind.