AOSC Forum Archive

LOCATION(S): Greenville, most games

PAYMENT PREFERENCE(S): Cash, Paypal

ITEM(S): Guarder Infinite torque up gears, Deep fire titanium half tooth piston, silent piston head and cylinder head, M(or SP, can't recall)160 spring

PRICE(S) MSRP as follows 50ish for gears, 30 for piston (old style, new ones are more expensive), 30ish for silent piston and cylinder heads, 15ish for spring.

Sell all for 65$

DESCRIPTION(S): These are some of the parts that I had in one of my DMRs for a while. I'm doing major upgrades at the moment, but not because any of these parts failed. They show very very little wear, worst are some marks on the spur gear from poor shimming by owner before me. Additionally, I can not verify what FPS the spring will produce, as it is a few years old.

Using these parts to upgrade your gun don't 100% require upgrades to the electrical system, in fact, with the infinite torque up gears, it is possible that a stock motor and battery can pull a spring as heavy as this M160. Don't expect a very fast rate of fire though.

PICTURE(S):

PART OUT?: Maybe, but it just makes sense to sell all of this together.

ACCEPT/OFFER TRADE(S)?: No

this isn't everything to make a DMR by your standards. u missing quite alot. -_-

I didn't say they were to MY standards... but good for a first build, on a budget

Lets seee.

18/1?

Is half tooth really worth it in a build pushing a 160?

Teflon around the cylinder head?

And all I would need after this would be a new motor and wiring correct?

Is cylinder head concave? I am interested in that, piston head too ifn you dont wanna split them up

Stop being so picky guys, for the mechanical aspects of a DMR, this is mostly what you need. Honestly, with these parts, you can make a DMR. Remember, a DMR is something that shoots over 400fps with .25s, and is semi only. There aren't other requirements.

Felix wrote:Lets seee.

18/1?

Is half tooth really worth it in a build pushing a 160?

Teflon around the cylinder head?

And all I would need after this would be a new motor and wiring correct?

They are the Guarder Infinite Torque up gears, seen here: http://www.airsoftatlanta.com/Guarder-I ... /34445.htm

They are closer to 45:1. ... slow, powerful gear set. Half tooth piston is required. .... Additionally, I'm glad you made me look that up, my memory was wwwwwwwwwwway off on the price of the gears!! Price has been adjusted accordingly.

Its debatable if you need a new electrical system to make these parts work together. Probably depends on quality of electrical system to begin with.

Capn; see the pic for what the cylinder head looks like.

Yes yes yes dat cylinder head. Its what i needddd. Theres a swamp kid that wants to make a dmr im pointing him here but if you part i wants

I'd use something different than that cylinder head. It really only works with that piston head that goes with it. If you're piecing something together, I'd get a differenc cylinder head, one with a flat back.

Star_folder wrote:I'd use something different than that cylinder head. It really only works with that piston head that goes with it. If you're piecing something together, I'd get a differenc cylinder head, one with a flat back.

i have that piston head, i just did not think about ordering a cylinder head with it when i picked it out, and miraculously no one carries it right now

....sold