Battery with a CASV

I broke my gun!
User avatar
Star_folder
AJAXian
AJAXian
Posts: 1671
Joined: Tue Jul 27, 2010 11:34 am
Location: Lexington/Pelion

Re: Battery with a CASV

Post by Star_folder » Thu Aug 04, 2011 1:24 pm

hmmm, alright. I guess you'll have to wire to the rear then.

Dominum
Global Moderator
Global Moderator
Posts: 6421
Joined: Mon Sep 28, 2009 10:14 am
Location: Swansea, SC

Re: Battery with a CASV

Post by Dominum » Thu Aug 04, 2011 6:22 pm

Rear wired ARs are better anyway.
PRincess and jsts ghost CERTIFIED "Tier 1 Operator"
[align=center]Image[/align]
[align=center]"Searching for my goats since 2009"
"All you have done here is take the typical leftist line and regurgitate it in a barely palatable,
quasi poetic, pseudo intellectual format. Quite frankly, that makes you a moron."[/align]
  ▲
▲ ▲
[align=center]V[/align]

Villid
I do in fact have a life.
I do in fact have a life.
Posts: 620
Joined: Wed Feb 17, 2010 9:45 am
Location: Rock Hill, SC
Contact:

Re: Battery with a CASV

Post by Villid » Thu Aug 04, 2011 6:53 pm

yeah, i suppose it would make changing the battery under fire quite a bit easier.

Thanks for the input everyone, appreciate it.

User avatar
SteevoLS
Admin
Admin
Posts: 5323
Joined: Mon Sep 28, 2009 8:16 am

Re: Battery with a CASV

Post by SteevoLS » Fri Aug 05, 2011 12:47 pm

Not only that, it makes maintenance infinitely easier since you can just pop the body pins and split the receiver apart in 10 seconds.
Image
There's no kill switch on awesome!

tom234
F.N.G.
F.N.G.
Posts: 1
Joined: Sat Aug 06, 2011 1:41 pm

Re: Battery with a CASV

Post by tom234 » Sat Aug 20, 2011 4:42 am

I think you can fit a nunchuck in there. so far I have been very satisfy with it, 3. I think Lipo pack for airsoft may be a good choice for you.here is the link for their airsoft batteries : http://www.all-battery.com/111vairsoftlipo.aspx

Dominum
Global Moderator
Global Moderator
Posts: 6421
Joined: Mon Sep 28, 2009 10:14 am
Location: Swansea, SC

Re: Battery with a CASV

Post by Dominum » Sun Aug 21, 2011 12:06 pm

Why on earth would you buy it there when you could buy it here: http://www.scairsoftsupply.com/categori ... Batteries/
PRincess and jsts ghost CERTIFIED "Tier 1 Operator"
[align=center]Image[/align]
[align=center]"Searching for my goats since 2009"
"All you have done here is take the typical leftist line and regurgitate it in a barely palatable,
quasi poetic, pseudo intellectual format. Quite frankly, that makes you a moron."[/align]
  ▲
▲ ▲
[align=center]V[/align]

User avatar
Jeremy314
I do in fact have a life.
I do in fact have a life.
Posts: 532
Joined: Mon Jan 25, 2010 11:27 pm
Location: Myrtle Beach, SC
Contact:

Re: Battery with a CASV

Post by Jeremy314 » Thu Aug 25, 2011 6:59 pm

I used this in my old KWA M4 CASV set up:
http://www.airsoftgi.com/product_info.p ... ts_id=3303

It might be hard to see, but it did fit into the DBoy's CASV I got, but I did do some minor modding of it when I got it.
Image

You just put all 4 sections around the barrel and it should work. Only problem I had was if I used the rails and if the screws touched the battery it would short it out some how (i have no idea how or why) but I could have pinched a wire and caused it to happen.
Image
VFC KAC PDW * WE PDW * KWA MP7A1 * KWA G36c * G&G CM M4 custom
2013 OPs: Mission: Double Cross Vet * SQA Skirmish 4/6/13 Vet
2014 OPs: OP: Iron Marches Vet

von_lounger
I love forums!
I love forums!
Posts: 285
Joined: Sun Oct 18, 2009 11:38 pm
Location: Myrtle Beach, SC
Contact:

Re: Battery with a CASV

Post by von_lounger » Fri Aug 26, 2011 1:49 pm

I had the same setup as Jeremy when I used to have a CASV and an M4, however I would avoid the trouble of trying to fit that battery in the CASV (which was still difficult even after some significant dremeling) and go with a buffer tube battery (which is the current setup on my 416 and much easier to use).
-Nick
[align=center]Image[/align]

[align=center]My Armoury[/align]

Villid
I do in fact have a life.
I do in fact have a life.
Posts: 620
Joined: Wed Feb 17, 2010 9:45 am
Location: Rock Hill, SC
Contact:

Re: Battery with a CASV

Post by Villid » Mon Aug 29, 2011 12:27 pm

Jeremy314 wrote:I used this in my old KWA M4 CASV set up:
http://www.airsoftgi.com/product_info.p ... ts_id=3303

It might be hard to see, but it did fit into the DBoy's CASV I got, but I did do some minor modding of it when I got it.
Image

You just put all 4 sections around the barrel and it should work. Only problem I had was if I used the rails and if the screws touched the battery it would short it out some how (i have no idea how or why) but I could have pinched a wire and caused it to happen.
I'm not even gonna try that, just gonna go with rear wiring. Thanks tho, best example of an answer to my question.

Glad to see yoru still alive by the way lol.

Post Reply