Page 1 of 1
Putting a full stock on my KWA sr10
Posted: Sun May 01, 2011 4:51 pm
by silverwolf
Ok, I am going to put on a full stock onto my kwa sr10 but i have run into a problem. I got the crane stock off but the wiring was still attached and i could not find out where to disconnect them from the gun. Any ideas?
Re: Putting a full stock on my KWA sr10
Posted: Sun May 01, 2011 5:08 pm
by Dominum
If it does not have an extension with a small tamiya plug then you will either have to feed it through as is or solder on your own. If you do, avoid tamiyas.
Re: Putting a full stock on my KWA sr10
Posted: Sun May 01, 2011 7:06 pm
by silverwolf
there is some casing around part of the wire where it looks like it connects it to the gear box but i dont know id i should take off the casing and put on the new wires and put elctrical tape around it. (i don't know if they are the right connectors)
Re: Putting a full stock on my KWA sr10
Posted: Sun May 01, 2011 8:38 pm
by Dominum
What do you mean by casing? Pics please.
Re: Putting a full stock on my KWA sr10
Posted: Sun May 01, 2011 8:54 pm
by SteevoLS
I was just working on one of these a few minutes ago. Just unscrew the fuse from the rear of the crane stock and it should slide back through the buffer tube.
Re: Putting a full stock on my KWA sr10
Posted: Mon May 02, 2011 6:40 am
by silverwolf
Their are some connectors wrapped in plastic but I don't know if I should touch it. And every time I try to post pics it does not allow it.
And Steevols ill try that
Re: Putting a full stock on my KWA sr10
Posted: Mon May 02, 2011 7:27 am
by Felix
post to photobucket then post the image link here