Elite Force 1911 Disassembled
Posted: Fri Jan 18, 2013 12:29 pm
There is not much online about taking the Elite Force 1911 apart. I had cleaned this pistol about 7 times and it just wouldn't get clean...the silicon oil was everywhere. I disassembled mine to clean it very very well. I soaked the hop up bucking in water with dawn soap to remove the oils. Hopefully I will get a chance to test it out soon and see if there is any improvement.
The following is the upper slide disassembled. Removing the outer and inner barrel required pulling a small pin out with pliers.
Next is the lower parts of the pistol.
Hopefully that gives an idea what the internals looks like for those looking to take down their Elite Force 1911.
The following is the upper slide disassembled. Removing the outer and inner barrel required pulling a small pin out with pliers.
Next is the lower parts of the pistol.
Hopefully that gives an idea what the internals looks like for those looking to take down their Elite Force 1911.