AOSC Forum Archive

G&G Combat Machine M4
-VFC self shimming gear set
-Echo 1 10 metal teeth piston
-MOSFET




KWA CQBR-1 M4




JG 416
-X-High Tech all steel teeth piston
-Cut down spring for CQB



JG G36C
-6.03mm Mad Bull TBB
-Mad Bull hop up bucking w/ fishbone nub
-JBU Metal Spring Guide
-Chronos: ~350fps




ICS MP5
-Mad Bull hop up bucking w/ fishbone nub
-Chronos: ~280fps



Double Eagle M56A
-Chronos: ~250fps

Looks good, Sean, but you need to get a suppressor for the G36.

Nice bud.  Looks like you'll be a riflemen.  Can't wait to see you in action. 

You should be running that MP5SD3 instead of the A4!             

Are you running that Glock on .12s? Those things rarely break 250 with a .20, much less 200.

Bushmaster wrote: Looks good, Sean, but you need to get a suppressor for the G36.

Thats a negative.  If i want the longer barrel for it, im gonna switch it up to an MG36

You should be running that MP5SD3 instead of the A4!

yaeh, but the SD is as long as a rifle, and i was kinda looking for a smaller gun for cqb

Not if you don't pull the stock out. 

theres also the issue of where i put the damn battey if i set it up like that

Small one in the hand guard.    You'll probably be only able to fit a small 8.4 or similarly sized LIPO in it though.  Sorry, it just saddens me to see that SD3 sit there. 

umm.  i cant seem to find where to put the battery in the SD hand guard.  I could swap it out and use the solid stock and the SD toh

Solid stock + SD front end = hotness.

Is the gearbox wired to the rear though?

yup.  already got the battery in the solid stock.  i can run either front or back battery, since the A5 wiring runs the lenght of the body, to the gearbox anyway

Hmm, this puts you in a pickle. 

I agree that it is kinda long for a CQB gun with that full stock.
I you decide you can't/don't want to use it and need some extra $$ let me know.  I can give it a home. 

i may just take you up on that